Drift punches are used to install or remove bolts and rivets. There are three types of drift punches: short, long, and drive pin punches. The length is important to the specific working conditions in each case. The end opposite the tip is used for striking.
- Prick punches are used to help center and locate during drilling processes
- A 50 degree angle at the tip permits exact marking and prevents the drill bit from slipping on the surface to be drilled
- Comply with American and European domestic and international standards
- Urrea warrants its product to be free from defects in material and workmanship. Any Urrea product which has not been altered, misused, or abuse, and fails during its normal useful life, will be replaced or repaired at no charge
WARNING: This product can expose you to chemicals including arsenic, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov